There are many types of plumbing leaks that you can face at home. Some of these can really flood the home, while others are more subtle and not so damaging.
How you approach a particular leak depends primarily on the type and intensity of the leak. You may be able to address some leaks yourself, while for others you may need to consult a plumber service in NYC.
If there is a leak in the joint, you can simple arrange for the tools and tighten the joint yourself. But is there is a leak in the pipe, you need to do a lot more than just tighten a joint. If you have some plumbing experience, you can remove the section of the leaking pipe and replace it with a new section; however, if you are a novice, you will need to call in a plumbing service in NYC to take charge.
Most homeowners believe small water leaks at the soldered copper joints can be easy to fix, but it’s easier said than done. If you don’t want to plumber in NYC, and want to try mending the leaking pipe yourself, here are a few things that you need to do.
Things you’ll need
When it comes to DIY projects, it is necessary to have some tools handy, which you can use to save time and frustration. Some of the tools you will need to mend a leaking pipe include:
- Slip joint pliers
- Plumbers tape
- Rags or towel
- Soldering torch
- Tube cutter
In addition to the tools, you will require the following materials:
In order to ensure you don’t have to run around sourcing material, when you are on to repairing the leaking pipe, you should have the following materials handy.
- Cloth sandpaper
- Soldering flux
- Lead-free solder
- Copper pipe and fittings
Procedure
When you have identified where the leak is, before doing anything else, shut off the water from the main valve leading into your home. Now, open the faucet at the end of the leaking pipe to drain out all the water from the leaky pipe.
Once the water has drained out completely, dry the surface outside the leaking area, and use the sandpaper on the area to scrap off all the corrosion on the pipe’s surface.
Take the soldering torch to flux around the entire joint or the area where the pipe is leaking. Use the torch to heat up the area to melt any previous solder. Add new solder over the area until a shiny ring of solder forms around the leaky area. After soldering, allow the pipe to cool down for a few minutes, now open the main valve and notice if the leak has been mended.
What if the leak continues?
If the drain hasn’t stopped leaking, the easiest thing that you can do is, turn of the main valve, allow the faucet to drain out water in the drain and then simply remove the entire leaking area (a joint of a plain area on the pipe) and then solder in a new fitting. If you need help with the replacement (since it’s not at all an easy task), you can reach out to 24 hour plumber service in Manhattan and have a handyman at your service.
0 Comments.